Significance and Use 3.1 This classification system is intended to encourage uniformity in reporting properties; to provide a common language for communications between suppliers and consumers; to guide engineers and designers in the test methods commonly used for commercially available materials; and to be versatile enough to cover new materials and test methods as they are introduced. 3.2 This system is based on the principle that nonmetallic gasket materials can be described in terms of specific physical and mechanical properties. This enables the user, or producer, to characterize a nonmetallic gasket based on properties that are important for the application.Scope 1.1 This classification system2 provides a means for specifying or describing pertinent properties of commercial nonmetallic gasket materials. Materials composed of asbestos, cork, cellulose, and other organic or inorganic materials in combination with various binders or impregnants are included. Materials normally classified as rubber compounds are not included, since they are covered in Classification D2000. Gasket coatings are not covered, since details thereof are intended to be given on engineering drawings or in separate specifications. Facing materials for laminate composite gasket materials (LCGM) are included in Classification System F104. Assembled LCGMs are covered in Classification F868. 1.2 Since all of the properties that contribute to gasket performance are not included, use of the classification system as a basis for selecting materials is limited. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
