Abstract
This specification covers the sampling, testing, and physical requirements of oxidized petroleum asphalt, which when applied in a sufficient thickness over a suitable subgrade and covered with a suitable cover material, will provide a satisfactory waterproof membrane for use as a canal, ditch, and pond lining. The asphalt shall not foam when heated are a specified temperature, when tested using appropriate methods, shall conform accordingly to the following properties: softening point (ring and ball); penetration points; ductility; flash point (Cleveland open cup); solubility in trichloroethylene; and loss in heating.
Scope
1.1 This specification covers an oxidized petroleum asphalt which, when applied in a sufficient thickness over a suitable subgrade and covered with a suitable cover material, will provide a satisfactory waterproof membrane for use as a canal, ditch, and pond lining.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system should be used independently of the other. Combining values in any way may result in nonconformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
