Abstract
This specification covers hard-drawn round copper alloy wires for electric conductors. The wires shall be made in any one of ten distinct alloys designated 8.5, 13, 15, 20, 30, 40, 55, 74, 80, and 85 in accordance with their increasing electrical conductivities. Specimens shall undergo tests to which they shall meet the required values for chemical composition, electrical resistivity, and mechanical and physical properties. The mechanical properties to be examined are elongation and tensile strength, while the physical properties in consideration are wire diameter, area, and density. The completed wire, to which no joints are to be made, shall be free from all imperfections not consistent with the best commercial practice.
Scope
1.1 This specification covers hard-drawn round copper alloy wires for electric conductors.
1.2 The copper alloy wires shall be made in any one of ten distinct alloys designated 8.5 to 85 in accordance with their increasing conductivities or designated by assigned UNS numbers (see Explanatory Note 1) as follows:
Copper Alloy UNS
No.
Copper Alloy UNS
No.
Alloy 8.5
C65100
Alloy 40
Alloy 13
C51000
Alloy 55
C16500
Alloy 15
Alloy 74
C19600
Alloy 20
Alloy 80
C16200
Alloy 30
C50700
Alloy 85
C16200
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3.1 Exception—The SI values of density and resistivity are to be regarded as standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
