Significance and Use
5.1 Dimensional measurements, properly interpreted, provide information with regard to the conductors, insulation, or jacket. The dimensional measurements provide data for research and development, engineering design, quality control, and acceptance or rejection under specifications.
Scope
1.1 These test methods cover procedures for the physical testing of thermoplastic insulations and jackets used on telecommunications wire and cable and the testing of physical characteristics and environmental performance properties of completed products. To determine the procedure to be used on the particular insulation or jacket or on the completed wire or cable, make reference to the specification for that product.
1.2 These test methods appear in the following sections of this standard:
Test Method
Section(s)
Dimensional Measurements of Insulations, Jackets, Miscellaneous
Cable Components, and of Completed Cable
4 – 9
Cross-sectional Areas
9
Diameters
6
Eccentricity
8
Thickness
7
Physical and Environmental Tests of Insulation and Jackets
10 – 25
Aging Test (Jackets Only)
24
Cold Bend (Insulation Only)
16
Environmental Stress Crack (Polyolefin Jackets Only)
21
Heat Distortion (Jackets Only)
22
Heat Shock (Jackets Only)
23
Insulation Adhesion
19
Insulation and Jacket Shrinkback (Oven Test)
14
Insulation Compression
20
Insulation Shrinkback (Solder Test)
15
Melt Flow Rate Change—Polyolefin Materials
12
Oil Immersion Test (Jackets Only)
25
Oxygen Induction Time (Polyolefin Insulation Only)
17
Oxygen Induction Time (Cable Filling Compound Only)
18
Tensile and Elongation Tests
13
Physical and Environmental Tests of Insulations and Jackets of
Completed Wire and Cable
26 – 42
Cable Torsion Test
38
Compound Flow Test (Filled Core Wire and Cable Only)
42
Corrugation Extensibility Test
36
Cable Impact Test
33
Jacket Bonding Tests
29
Jacket Notch Test
32
Jacket Peel or Pull
28
Jacket Slip Strength Test
30
Procedure
Section(s)
Pressure Test (Air Core Wire and Cable Only)
40
Sheath Adherence Test
31
Water Penetration Test (Filled Core Wire and Cable Only)
41
Wire and Cable Bending Test
34
Wire breaking strength
37
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard, except where only SI units are given.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statement see 19.1.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.