Significance and Use
3.1 This practice is provided to facilitate comparison of physical and mechanical properties of refractory materials by establishing uniform presentation of data.
3.2 Units have been chosen, where possible, to result in numbers of magnitude familiar in the refractories industry, that is, g/cm3 rather than the SI preferred unit kg/m3. It is recommended that SI prefixes be selected for use with the units such that the resulting numerical values lie between 0.1 and 1000. For most properties, the prefixes kilo (k) and mega (M) are preferred. Other prefixes are given in the following table:
Multiplication
Factor
Prefix
Symbol
109
giga
G
106
mega
M
103
kilo
k
102
hectoA
h
101
dekaA
da
10−1
deciA
d
10−2
centiA
c
10−3
milli
m
10−6
micro
μ
10−9
nano
n
(A) To be avoided where practical.
3.3 The conversion factors, which have been selected for their general utility in the refractories industry, have been taken from Practice E380, where possible. For uniformity, they have been presented to four decimal places. In use, the converted values should be rounded to the same number of significant figures as in the original value.
Scope
1.1 This practice presents the units to be employed for reporting the properties of refractories, such as density, crushing stress, modulus of rupture, tensile stress, thermal conductivity, and permeability.
1.2 For convenience, a table of conversion factors between inch-pound units and SI units is included.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
