Abstract
This specification covers a group of common requirements that, unless otherwise specified in an individual specification, shall apply to ferroalloys and other alloying materials. The chemical analysis method shall be agreed upon by the purchaser and supplier. Unless otherwise specified, the material shall be sampled for determination of chemical composition and size.
Scope
1.1 This specification covers a group of common requirements that, unless otherwise specified in an individual specification, shall apply to ferroalloys and other alloying materials under each of the following ASTM specifications:
Title of Specification
ASTM Designation
Ferromanganese
A99
Ferrosilicon
A100
Ferrochromium
A101
Ferrovanadium
A102
Ferromolybdenum
A132
Molybdenum Oxide Products
A146
Ferroboron
A323
Ferrotitanium
A324
Chromium Metal
A481
Ferrochrome-Silicon
A482/A482M
Silicomanganese
A483/A483M
Calcium-Silicon Alloys
A495
Ferrocolumbium
A550
Electrolytic Manganese Metal
A601/A601M
Nickel Oxide Sinter
A636
Ferromanganese Silicon
A701/A701M
Titanium Scrap for Use in Deoxidation and Alloying of Steel
A845
Aluminum Scrap for Use in Deoxidation and Alloying of Steel
A846
Silicon Metal
A922
1.2 This specification also covers a group of supplementary requirements which may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.
1.3 In case of conflict between the requirements of the individual specification and this general specification, the former shall prevail.
1.4 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.4.1 This specification is expressed in both inch-pound units and in SI units (within the text, the SI units are shown in brackets); however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.